Supersharp AFM Probes

Atomic Force Microscopy (AFM) is a very powerful tool to characterize finest features, smallest objects and surface properties like roughness on the nanometer scale. A sharp AFM tip mounted at the end of an AFM cantilever is scanned in lines over a surface and detects changes in height. Those changes are either deflecting the AFM cantilever or change its resonance frequency and amplitude. A laser beam is directed on the backside of the AFM cantilever whereon the AFM tip is mounted, and then reflected into a photo diode.

In the photo diode the laser position is monitored and the Root Mean Square (RMS) value of the oscillation is calculated. Any change of the AFM tip in height (z-position, respectively) will cause a change of the laser position in the photo diode and the RMS value. The change is passed to the feedback loop, which changes the position of the z-piezo until the original value of the RMS amplitude is restored. The change in the height of the z-piezo is equal to the change in the height on the sample surface.

To enable high-resolution imaging, photo detector, feedback loop and z-piezo of the Atomic Force Microscope) have to work with the highest accuracy possible to ensure that the AFM tip-sample interaction is kept small to avoid damage to the AFM tip and a constant oscillation amplitude is ensured, so that the AFM tip-sample interaction remains stable. The feedback system must be fast, so that the AFM tip is quickly moved away or approached in response to changes in topography. If one of the components is too slow the AFM tip might either be damaged or not properly tracking the sample surface. If their accuracy is not sufficient or their noise levels are too high, smallest changes in height can`t be detected.

To maximize resolution in lateral directions, firstly, a stage and positioning system with highest accuracy – often a closed-loop system – and a low noise is required. Secondly, the sample has to be fixed properly and, often missed, the objects to be imaged have to be in a stable contact with the surface underneath. Furthermore, the resolution could be enhanced dramatically if the AFM is operated in vacuum. Under standard atmospheric conditions the AFM cantilever is damped by the surrounding air molecules. Additionally, almost every surface under atmospheric pressure is covered by a very thin water film. The presence of this water film has an even stronger influence. Both influencing factors could be removed by working in vacuum.

Finally, to obtain the best resolution possible, an adequate AFM probe has to be chosen. Usually, we are talking about high resolution AFM probes with an AFM tip radius below 3nm compared to a mean AFM tip radius of standard AFM probes with 7 to 10nm. Structures can only be resolved if their radius or distance is larger than the AFM tip radius. For example, a 5nm gap cannot be resolved properly with a 7nm radius AFM tip, whereas an AFM tip with a radius of 3nm can correctly image this structure.