PPP-QLC-MFMR

The NANOSENSORS™ PPP-QLC-MFMR AFM probe combines the low disturbance of magnetic samples by a soft magnetic coating with the high mechanical quality factor under ultra high vacuum conditions of the Q30K-Plus-Series. Low coercivity and a Q-factor of more than 35,000 enable magnetic force microscopy of soft magnetic samples and high operation stability under UHV conditions. Due to the low coercivity of the AFM tip coating the magnetisation of the AFM tip will easily get reoriented by hard magnetic samples.

The AFM probe offers unique features:

• soft magnetic coating on the AFM tip side (coercivity of app. 7.5Oe, remanence magnetization of app. 225emu/cm3)
• effective magnetic moment 0.75x of standard MFM AFM probes
• excellent AFM tip radius of curvature
• magnetic resolution better than 35nm
• Al coating on detector side of AFM cantilever enhancing the reflectivity of the laser beam by a factor of about 2.5
• excellent mechanical Q-factor under UHV conditions for high sensitivity
• precise alignment of the AFM cantilever position (within +/-2µm) when used with the Alignment Chip
• compatible with PointProbe® Plus XY-Alignment Series

As both coatings are almost stress-free the bending of the AFM cantilever due to stress is less than 3.5% of the AFM cantilever length. For enhanced signal strength the magnetization of the AFM tip by means of a strong permanent magnet prior to the measurement is recommended.

This AFM probe features alignment grooves on the back side of the holder chip.